The SW115 is a very powerful band pass rear horn-loaded subwoofer designed for use in night - club applications, although it is also ideally suited for concert touring and festivals. High-velocity band pass horn-loading techni - que, gives a precise cone control, resulting in a deep and fast bass response at high power levels, with a very high sensitivity. The response given with this subwoofer is very deep, starting at 38 Hz, but at the same time it de - livers tremendous punch due to its fast transient response. The SW115 has built in proprietary hardware for simple, fast and safe rigging. The enclosure has been made with the latest techniques ensuring a perfect and rigid construc - tion. Weatherized finish is provided, as the cabinet is coated with rugged Durawound texture finish and protected with specially treated grills. The SW115 can be supplied in active Pcc ver - sion or passive one. SW115 PCC is self-powered with one way amplification and controlled with a DSP built inside, (PCC Original or PCC Advanced Series), with ten fully parametric eqs, delay, crossover points, compressors, gain controls, 30 band eq, phase res - ponse alignment circuitry, etc. With the mouse of a small laptop, the sound engineer can vary in real time, any of the parame - ters on each of the speakers. After starting TECNARE software, the sys - tem will identify the speakers connected to the net, showing them in the network window of the program. You only have to choose the speaker to be managed, and six different windows will be available for the sound engineer to control everything. The program allows the storage of as many presets as desired, which can be loaded any time, four of them without using the software, but only clicking on the rear panel. With this way of opera - tion, sound systems become far more flexible. A lot of patching can be avoided, reducing rack controls dras - tically. At the same time, equalization, crossovering, limiting, delay of each box no longer have to be the same, without the hiero - glyphic needed to do that in a conventional way for a complex installation. The system incorporates as standard a very powerful audio analyzer. The sound engineer can check the system’s response, in spectrum or trans - fer mode, while modifying any of the various audio controls available on the system. It also incorporates a set-up screen, with an audio generator, markers for a delay measurement, and vu-meters. Impulse response, phase response and polar plot analysis are also available.

Frequency Response: 38 Hz – 800 Hz ±4dB, measured on axys.
Nominal Dispersion: not  available.
Impedance: 8 Ohm.
Sensitivity: 102dB (1w/1m)
Calculated Max Spl: 134dB continuous/140 dB peak.
Power Handling:
#1000 W nominal.
*2000 W continuous.
Dimensions (HxWxD): 735x445x690 mm
Net Weight: 52 kg selfpowered Pcc version.
Components: 1×15″ LF driver.
Construction: 18mm birch plywood. Finished in black semi-matt textured Durawound weatherized coating. One recessed carrying handle.
Grille: Powder coated perforated steel with acoustically transparent reticulated foam.

AMPLIFIER (self powered series)
Type: Class H inc SMPA and networked DSP.
Power Output: 1080 watts r.m.s. @ 8 ohms (1kHz, 0.01% THD)
Dynamic Range: 110dB
Input Clip: 10dBu
Bandwidth: 20Hz – 20kHz ±0.5dB

Power Requirements: 100V to 240V AC @ 50/60Hz

 Construction: 18mm birch plywood. Finished in black semi-matt textured Durawound weatherized coating. One recessed carrying handle. Grille: Powder coated perforated steel with acoustically transparent reticulated foam. Flying Hardware: M8 rigging points.

http://www.tecnare.com/pdf_NEW/Tecnare_IbzaSW115.pdf